EC000 Custom Color, EC Spray Paint

Endura-Clad Spray Paint is a modified acrylic enamel aerosol coating that is designed for touch-up and repair of previously coated surfaces. Quickly touch-up scratches, chips, dings and other blemishes on your roll door. DIY friendly. 

Features

• Easy DIY Application
• Great for Touch-Up
• Fast Drying
• Large Selection of Current & Legacy Door Colors

Recommended Use

Touch-Up For:

• Business machines
• Decorative metal
• Over high solid polyurethane
• Over industrial water-base enamels
• Over powder coatings
• Marking and identification
• Selected plastics

Directions For Use

• Check color and gloss for adequacy on scrap material prior to application. 
• Check adhesion to substrate, scuff sanding and solvent wipe may be required.
• Surfaces to be sprayed must be clean and dry. 
• Shake can vigorously for 2 minutes before using and occasionally during use.
• Remove metal cap and spray by depressing plastic spray head button. 
• Spray at 14 to 24 inches from surface to be coated, using short bursts for best results.
• Several light coats are better than a single heavy coat.
• If paint runs, can is too close or finish is being applied too heavily. 

Coverage

20 - 30 sq. ft. per can at DFT  0.5 mil. with no  loss. 

Dry Time

Dries to touch in about 30 minutes. Dries hard in about 2 hours. (At 1.5 mils dry film thickness, 78° F, 50% RH)

Colors

Large selection of current and legacy door colors. 

Clean up

After spraying, turn can upside down. Push button about 2 seconds or until paint in siphon tube is exhausted. Remove plastic spray head and run fine wire through spray orifice or hole. If necessary, clean head with lacquer thinner.